Rohde & Schwarz XT 4410A - Page 135

065 75$16&(,9(5  ; $  ; $
Operator’s Manual • Use under Special Conditions
6076.0822.12.01 – 3.21 –
 ,QWURGXFWLRQWR/RDGHG8VHUDQG&XUUHQW3DJHV
Page storage within the radio is based on a redundancy concept. There are three areas for the
Preset Page to be stored:
q Loaded Page area: pages with factory and / or customer-predefined settings
q User Page area: copies of Loaded Pages that can be edited
q Current Page area: currently used page
 /RDGHG3DJH$UHD
Pages with factory and / or customer-predefined settings are referred to as Loaded Pages and
can only be changed by the administrator. Identical copies of the Loaded Pages are used as
basis for User Pages and Current Pages, which can then be edited by the operator as required.
Normally Loaded Pages will be loaded into the radio via the Service and Maintenance Tool
ZS 4400. In some cases, however, it may be necessary to enter these pages manually, which
can be done only by an administrator having the required setup PIN. For editing a Preset Page
an editor (Menu 710 (EDIT PRESET PAGE FIX.FRQ)) is available. Softkey SAVE AS is used
to store the edited Preset Page as Loaded Page and simultaneously as User Page.
)LJ  (GLWLQJDQG6WRULQJD/RDGHG3DJH
User Page
12
Loaded Page
12