Rohde & Schwarz XT 4410A - Cleaning and Touch-up Procedures

065 75$16&(,9(5  ; $  ; $
Operator’s Manual • Maintenance
– 5.2 – 6076.0822.12.01
 7DNLQJ&DUH
Such measures involve cleaning and touching up slight blemishes in the varnish coat of the
transceiver. The following materials are required:
 &OHDQLQJ
:HDUJRJJOHVZKHQZRUNLQJZLWKFRPSUHVVHGDLU
LQRUGHUWRDYRLGH\HLQMXULHV
&$87,21
'LUHFWFRPSUHVVHGDLUILUVWWRZDUGVJURXQGXQWLOQRPRUHFRQGHQVHGZDWHULVFRQWDLQHG
LQWKHDLUMHW
.HHSDPLQLPXPGLVWDQFHRIFPEHWZHHQFRPSUHVVHGDLUDQGWUDQVFHLYHU
1. First of all clean surfaces of the unit with compressed air.
2. Continue cleaning with a soft brush or a duster.
3. Clean heavily contaminated surfaces, especially grease stains, with a soft, lint-free cloth
moistened with suds.
 5HWRXFKLQJWKH3DLQW:RUN
Touch up the paint work of the M3SR Transceiver as follows:
1. Remove any loose paint particles from the area to be retouched.
2. Clean area to be retouched with a soft, lint-free cloth soaked in suds or similar.
3. Wait for the suds to dry out.
4. Retouch with paint carefully and allow plenty of time to dry out.
5. Once the first coat is completely dry, apply a second coat and again allow it to dry. The
repair is thus completed.
,WHP 'HVFULSWLRQ
1 Soft brush
2Duster
3 Cleaning compound, e.g.
suds, household detergent
4 Varnish
Front panel:
RAL 7947 telegrey
Chassis:
KB90 grey
:$51,1*