065 75$16&(,9(5 ; $ ; $
Operator’s Manual
– I.6 – 6076.0822.12.02
Rx antenna connector X5031 ................... A1.15
RX LEVEL....................................................3.48
6
S400U..........................................................3.34
S400U protocol ........................................... A2.1
Safety rules....................................................1.9
SAVE AS......................................................3.68
SAVE PAGE ................................................2.41
SAVE TO CTRL UNIT..................................3.77
SAVE TO RADIO.........................................3.39
Saves address list to the control unit ..3.77, 3.79
Saves the edited PRESET PAGE under
a new PRESET number...............................3.68
Scanning..................................................... A2.4
Scheduled maintenance ................................5.1
SELECT.......................................................2.15
SELECT and 10 x LOCAL within 10 sec......2.17
Select by turning the tuning knob.................2.12
Selection of
access level ...........................................2.30
active PTT line 3.56, 3.57
AF AGC attack time ...............................3.50
AF AGC decay time ...............................3.50
antenna input.........................................3.51
channel spacing.....................................3.69
channel spacing value ...........................2.38
clipper level............................................3.51
clock frequency for reference
output X11 .............................................3.46
clock source...........................................3.46
communication line for PTT mapping ....3.56
configuration of the power level for
the external power amplifier...................3.53
date format.............................................3.80
edit fields for power levels .....................3.52
equipment for CBIT..................................4.6
equipment for error list.............................4.8
equipment for radio inventory ................3.32
frequency mode .....................................3.80
guard receiver AF signal........................2.35
interface for level setting........................3.47
modulation type ............................2.36, 3.67
parity ......................................................3.35
pre-defined communication mode 2.37, 3.69
protocol type ..........................................3.34
PTT level of the current line...................3.57
radio operating mode.............................2.35
sensitivity ...............................................3.50
serial port standard ................................3.35
section of the Preset Page to be
edited or viewed.....................................3.67
transmit power ..............................2.36, 3.67
Tx offset value ..............................2.38, 3.70
Selection within a set of values....................2.12
Selects the
entire radio or comline for IBIT ................4.4
input to be monitored .............................3.46
radio operation mode.............................3.68
SENSITIV LW NOISE..................................3.50
Serial No. ...........................................3.33, 3.73
Server ............................................................1.6
Service / FILL connector X4 ....................... A1.2
Service and Maintenance Tool ZS 4400... A1.31
SESSION.....................................................2.30
SET OPTIONS.............................................3.42
Sets the default IP .......................................2.17
Setting of a
AM modulation depth.............................3.52
AM transmit power.................................3.52
common frequency for Tx and
Rx operation ..........................................2.36
display brightness..................................3.81
display contrast......................................3.81
display timer...........................................3.81
FM transmit power.................................3.52
front key illumination..............................3.80
LED brightness......................................3.80
logical radio address..............................2.27
new date ................................................3.40
new time ................................................3.40
number of bits in the telegram ...............3.35
number of stop bits ................................3.35
response threshold of the S/N squelch..3.51
value for fine tuning of synthesizer
FM modulator.........................................3.54
value for FM Deviation Narrowband ......3.54
value for FM Deviation Wideband
(analog)..................................................3.54
value for TX Deviation for
Link 11 operation ...................................3.54
SETUP.........................................................3.64
SETUP... .....................................................3.64
SIDETN VOLUME .......................................3.49
Softkey.........................................................2.10
ACTIVE..................................................3.57
ADD ADDR............................................3.77
ADDRESS LIST... ........................3.36, 3.77
AF AGC .................................................2.38
ALC DECAY ..........................................3.47
AM .........................................................3.52
AM MOD................................................3.52
ATTACK.................................................3.50
AUDIO FRONTP... ................................3.61
AUDIO MAPPING... ..............................3.58
BAND.....................................................2.43
BITRATE................................................3.35
BITS/CHAR............................................3.35
BRIGHT .................................................3.81
CBIT... ............................................4.6, 4.22
CHAN SP......................................2.38, 3.69
CHANGE TYPE.....................................3.77
CL ..........................................................3.44
CLEAR LIST ...................................4.8, 4.24
CLIP LEV...............................................3.51
CLIPPER ...............................................2.37
CLK SRC ...............................................3.46
CODEC..................................................3.47
COMM ..........................................2.37, 3.69
CONNECT....................................2.30, 3.53
CONTR..................................................3.81
CONTROL PORT... ..............................3.34
COUNT..................................................3.65
CU... MAINT .................................3.71, 4.18
DATE ............................................3.40, 3.80
DECAY ..................................................3.50
DEFAULT MODE...................................3.68
To Next Page
Loading...
