Rohde & Schwarz XT 4410A - Page 84

065 75$16&(,9(5  ; $  ; $
Operator’s Manual • Use under Normal Conditions
– 2.24 – 6076.0822.12.02
 065 7UDQVFHLYHU; $
2.5.2.2.1 Minimum Requirements
Before putting the M3SR Transceiver X. 4460A into operation make sure that the following
minimum requirements are met:
• Control Unit GB 4000C, mod. 03 (remote version) is connected with the transceiver via
LAN.
• Control Unit GB 4000C, mod. 03 is connected with the power distribution system.
• AC Power Supply IN 4000A (or a battery complying with the technical specifications) is
available.
• Antenna is connected.
• See also chapter 2.4 "Basic Cabling".
2.5.2.2.2 Switching On
+ Press key ON / OFF on the Front Panel (see figure).
+ Press key ON / OFF on Control Unit GB 4000C, mod. 03.
.H\ 212))
switches the transceiver on / off
.H\ 212))
switches the control unit on / off