Putting the Analyzer into Operation
R&S
®
ZNB/ZNBT
16Getting Started 1316.0062.02 ─ 26
state, it is safe to switch the AC power off and disconnect the instrument from the
power supply. In ready state, all modules are power-supplied. When switched to ready
state, the analyzer initiates its startup procedure.
Observe the instructions for startup and shutdown in Chapter 2.7, "Starting the Ana-
lyzer and Shutting Down", on page 14.
2.9 Connecting External Accessories
The analyzer's standard PC interfaces (Monitor, USB, LAN) can be used to connect
various accessories:
●
An external monitor expands/displays the Windows
®
desktop, which is, by default,
covered by the Vector Network Analyzer (VNA) application window in full-screen
mode.
●
External keyboard and mouse enable/simplify local control, in particular manual
(GUI) operation of the VNA application.
●
A printer can be used to create hard copies of the measurement diagrams and
traces from within the VNA application.
●
A LAN connection can be established to access the analyzer's mass storage or
control the analyzer from an external PC.
●
Instruments equipped with controller LPW11 can also be remote controlled via
USB.
For the R&S ZNBT, external monitor and mouse are required for local operation. The
R&S ZNB can be fully controlled by tapping the touchscreen and front panel keys.
2.9.1 Connecting a Monitor
A standard monitor can be connected to the DVI-D connector of the R&S ZNB/ZNBT.
No extra configuration is required.
Instruments equipped with controller LPW11 also offer a DisplayPort.
Safety aspects
The monitor must be connected while the instrument is switched off (or in standby
mode). Otherwise correct operation cannot be guaranteed.
Select SYSTEM > [DISPLAY] > "View Bar" > "Hard Key Panel On" from the menu bar
of the VNA application window to add the (virtual) "Hard Key Panel" to the application
window.
Connecting External Accessories
To Next Page
Loading...
