Rohde & Schwarz ZNB - Connecting a LAN Cable; Connecting a USB Cable for Remote Control; Minimizing the VNA Application

Putting the Analyzer into Operation
R&S
®
ZNB/ZNBT
18Getting Started 1316.0062.02 ─ 26
To access Windows
®
, press the Windows key on the front panel (R&S ZNB only) or on
the external keyboard.
You can load updated and improved driver versions or new drivers from an installation
disk, USB memory stick or another external storage medium. Alternatively, if the ana-
lyzer is integrated in a network, you can install driver data stored in a network directory.
In either case, use the "Add Printer" wizard to complete the installation.
Printer configuration
Use the "Printer Setup" dialog of the firmware (SYSTEM > [PRINT] > "Print...") or the
Windows
®
printer management to configure the printer properties and printing prefer-
ences.
2.9.5 Connecting a LAN Cable
A LAN cable can be connected to the LAN connector on the rear panel of the analyzer.
To establish a LAN connection, proceed as follows:
1. Refer to Chapter 2.12.1, "Assigning an IP Address", on page 20.
2. Connect a CAT6 or CAT7 LAN cable to the LAN port.
The LAN port of the analyzer is an auto-crossover Ethernet port. You can connect it to
a network, but you can also set up a direct connection to a computer or another instru-
ment. For both connection types, you can use either crossover or straight through
(patch) cables.
The IP address information is shown in the SYSTEM > [SETUP] > "Remote Settings"
softtool tab. For the R&S ZNBT, it is also shown on the Mini display.
2.9.6 Connecting a USB Cable for Remote Control
Instruments equipped with controller LPW11 can also be remote controlled via USB. To
prepare for remote control operation, connect a suitable USB 2.0 or 3.0 cable to the
type B "USB Device" port on the rear panel of the instrument. With direct connection to
a master device, a connecting cable A-B (plug type A onto plug type B) must be used.
For more information, refer to the Remote Control chapter of your analyzer's help sys-
tem or user manual.
2.10 Minimizing the VNA Application
With a minimized VNA application, you can access your analyzer's Windows
®
desktop
or run other applications.
Minimizing the VNA Application