Rohde & Schwarz ZNB - Using Front Panel Keys

Operating the Instrument
R&S
®
ZNB/ZNBT
55Getting Started 1316.0062.02 ─ 26
4.5.1 Using Front Panel Keys
On a R&S ZNB you can use the keys in the DATA ENTRY keypad to enter numbers,
units, and characters.
To enter a numeric value:
1. Select a numeric data input field to activate it.
2. Press the data entry keys.
● Use [0] to [9] to enter the corresponding numbers.
● Use [.] to enter a decimal point.
● Use [-] to change the sign of the value.
●
Use [G/n], [M/μ], [k/m], or [x1] to multiply the entered value with factors of 10
(-)9
,
10
(-)6
, 10
(-)3
or 1 and to add the appropriate physical unit.
To enter a character string:
1. Tap a character data input field to activate it.
2. Press the DATA ENTRY keys as if you were writing a short message on your
mobile phone.
● Use [0] to [9] to enter the corresponding numbers.
● Use [.] and [-] to enter a dot or hyphen.
● Use Use [G/n], [M/μ], or [k/m] to enter the letters G, M or K (case-insensitive).
● Use the [←] key to correct wrong entries, deleting the character to the left of
the current cursor position.
● Press [ENTER] to complete an entry.
● Press [ESC] to discard the entries made.
3. To enter letters other than G, M or K, you can also use one of the methods descri-
bed in the following sections:
● Chapter 4.5.3, "Using the Analyzer's On-Screen Keyboard", on page 56
Entering Data