Command Reference
R&S
®
ZNB/ZNBT
1139User Manual 1173.9163.02 ─ 54
If the file name is prefixed by "SD:", the file is saved to the SD
card inserted at the calibration unit (if available/accessible).
<TestPort1> Number of first test port.
<CalUnitPort1> Number of the calibration unit port to whom the first test port
(<TestPort1>) is assigned.
<TestPort2> Number of second test port...
Usage: Setting only
Manual operation: See "Test Port Assignment" on page 488
[SENSe:]CORRection:COLLect:AUTO:CKIT:PORTs:ADD
<Characterization>,
<TestPort1>, <CalUnitPort1>, <TestPort2>...
Extends or modifies an existing characterization of the active calibration unit (SYSTem:
COMMunicate:RDEVice:AKAL:ADDRess).
This functionality is not available at the GUI.
Setting parameters:
<Characterization> Location of an existing characterization (e.g. created using
[SENSe:]CORRection:COLLect:AUTO:CKIT:PORTs).
– A VNA cal kit file name *.calkit without path refers to a
specific cal kit file stored in the internal memory of the active cal-
ibration unit.
– A VNA cal kit file name without path but prefixed with "SD:"
refers to a specific cal kit file stored on the SD card inserted at
the active calibration unit.
– A VNA cal kit file name *.calkit with path refers to a spe-
cific cal kit file stored in an arbitrary directory on the analyzer.
<TestPort1> Number of first test port.
<CalUnitPort1> Number of the calibration unit port, to whom test port <Test-
Port1> is assigned.
<TestPort2> Number of the second test port ...
SCPI Command Reference
To Next Page
Loading...
