Rohde & Schwarz ZNB - Page 1199

Command Reference
R&S
®
ZNB/ZNBT
1199User Manual 1173.9163.02 ─ 54
<Denominator> Range: 1, 2, 3 ...
*RST: 1
Example: See [SENSe<Ch>:]FREQuency:CONVersion:MIXer:
MFFixed
Manual operation: See "Multiplication tab" on page 565
[SENSe<Ch>:]FREQuency:CONVersion:MIXer:RFPort <Port>
Selects a test port as source port for the RF signal.
Suffix:
<Ch>
.
Channel number
Parameters:
<Port> Test port number
Range: 1 to number of test ports
*RST: 1
Example: See [SENSe<Ch>:]FREQuency:CONVersion:MIXer:
MFFixed
Manual operation: See "Port selection" on page 564
[SENSe<Ch>:]FREQuency:CONVersion:MIXer:STAGes <Stages>
Selects the number of mixer stages for scalar mixer measurements.
Suffix:
<Ch>
.
Channel number
Parameters:
<Stages> Number of mixer stages
Range: 1 | 2
*RST: 1
Example: See [SENSe<Ch>:]FREQuency:CONVersion:MIXer:
MFFixed
Manual operation: See "2nd Mixer" on page 566
[SENSe<Ch>:]FREQuency:CONVersion:MIXer:TFRequency<Stg>
<IFConversionMode>
Selects the frequency conversion mode of the IF signal.
Suffix:
<Ch>
.
Channel number.
<Stg> Mixer stage (1 or 2; see [SENSe<Ch>:]FREQuency:
CONVersion:MIXer:STAGes.
SCPI Command Reference