Rohde & Schwarz ZNB - Page 1268

Command Reference
R&S
®
ZNB/ZNBT
1268User Manual 1173.9163.02 ─ 54
Example: See SOURce<Ch>:GROup<Grp>:SIMultaneous:FOFFset:
STATe
Manual operation: See "Minimum Offset" on page 541
SOURce<Ch>:GROup<Grp>:SIMultaneous:FOFFset:MOFFset:DVALue
<StartFreq>
This command is related to Parallel Measurement with Frequency Offset. It specifies
the minimum frequency offset directly.
Note that this only takes effect if SOURce<Ch>:GROup<Grp>:SIMultaneous:
FOFFset:MOFFset:MODE is set to DIRect.
Suffix:
<Ch>
.
Channel number.
If unspecified, this parameter is set to 1.
<Grp>
Parameters:
<StartFreq> The minimum frequency offset.
To get the resulting frequency offset, the minimum frequency off-
set is rounded to a multiple of the current frequency step size.
Range: 0 Hz to 17 MHz
*RST: 1 MHz
Default unit: Hz
Example: See SOURce<Ch>:GROup<Grp>:SIMultaneous:FOFFset:
STATe
Manual operation: See "Minimum Offset" on page 541
SOURce<Ch>:GROup<Grp>:SIMultaneous:FOFFset:MOFFset:BWFactor <arg0>
This command is related to Parallel Measurement with Frequency Offset. It defines the
multiplication factor that is used to calculate the minimum frequency offset from the
measurement bandwidth.
Note that this only takes effect if SOURce<Ch>:GROup<Grp>:SIMultaneous:
FOFFset:MOFFset:MODE is set to BANDwidth.
Suffix:
<Ch>
.
Channel number.
If unspecified, this parameter is set to 1.
<Grp>
SCPI Command Reference