Command Reference
R&S
®
ZNB/ZNBT
1288User Manual 1173.9163.02 ─ 54
<ListNo> Number of point in the list. This suffix is ignored; the command
deletes all points.
Example: See SOURce<Ch>:POWer<PhyPt>:CORRection:
TCOefficient:CALibration
Usage: Event
Manual operation: See "Frequency / Transm. Coefficients: Insert, Delete, Delete
All" on page 495
SOURce<Ch>:POWer<PhyPt>:CORRection:TCOefficient:DELete<ListNo>[:
DUMMy]
Deletes a single point no. <ListNo> in the power loss list.
Suffix:
<Ch>
.
Calibrated channel number. This parameter is ignored; the trans-
mission coefficient settings are valid for all channels.
<PhyPt> Calibrated port number. This parameter is ignored; the transmis-
sion coefficient settings are valid for all sources.
<ListNo> Number of point in the list.
Example: See SOURce<Ch>:POWer<PhyPt>:CORRection:
TCOefficient:CALibration
Manual operation: See "Frequency / Transm. Coefficients: Insert, Delete, Delete
All" on page 495
SOURce<Ch>:POWer<PhyPt>:CORRection:TCOefficient:FEED <Trace>
Selects a trace which provides the points for the power loss list.
Suffix:
<Ch>
.
Calibrated channel number. This parameter is ignored; the trans-
mission coefficient settings are valid for all channels.
<PhyPt> Calibrated port number. This parameter is ignored; the transmis-
sion coefficient settings are valid for all sources.
Setting parameters:
<Trace> String parameter for the trace name, e.g. 'Trc1'. The trace must
exist in the active recall set.
*RST: n/a
Example: See SOURce<Ch>:POWer<PhyPt>:CORRection:
TCOefficient:CALibration
Usage: Setting only
Manual operation: See "Get Trace..." on page 496
SCPI Command Reference
To Next Page
Loading...
