Rohde & Schwarz ZNB - Page 547

GUI Reference
R&S
®
ZNB/ZNBT
547User Manual 1173.9163.02 ─ 54
6.12.4 Intermod. Tab
Controls the intermodulation measurement including power calibration. The intermodu-
lation measurement requires options R&S ZNB/ZNBT-K4 and R&S ZNB/ZNBT-K14.
The results can be selected using the "Intermod." tab of the "Meas" softtool, see Chap-
ter 6.2.4, "Intermod. Tab", on page 273.
The Intermodulation Presetting Wizard guides through the measurement configuration.
Background information
Refer to Chapter 5.7.4.3, "Intermodulation Measurements", on page 222.
6.12.4.1 Controls on the Intermod Tab
The buttons on the "Intermod" tab open the following dialogs:
●
"Intermod Wizard...": See Chapter 6.12.4.2, "Intermodulation Presetting Wizard",
on page 549
●
"Define Intermod...": See Chapter 6.12.4.3, "Define Intermodulation Distortion
Measurement Dialog", on page 553
●
"Frequencies Powers...": See Chapter 6.12.4.4, "Frequencies and Power Dialog",
on page 556
●
"Generators...".: See Chapter 6.17.4.4, "External Generators Dialog",
on page 725
●
"Intermod Pwr Cal...": See Chapter 6.12.4.5, "Intermod. Pwr. Cal Wizard",
on page 557
Channel Config Softtool