GUI Reference
R&S
®
ZNB/ZNBT
592User Manual 1173.9163.02 ─ 54
Figure 6-53: Fixture Modeling Dialog: ISD - Balanced Ports
Figure 6-54: Fixture Modeling Dialog: EZD - Single Ended Ports
The fixture modeling proceeds in the following steps:
1. Measure one or more test coupons for the related fixture; see Chapter 6.13.5.2,
"Measure Coupon", on page 594
The tools differ in the available coupon types.
2. ISD and SFD only: measure the DUT with the fixture; see Chapter 6.13.5.3, "Mea-
sure DUT + Test Fixture", on page 595
3. Run the selected tool to calculate the Touchstone files modeling the test fixture;
see Chapter 6.13.5.4, "Save Fixture Model", on page 596.
The calculated sNp file(s) can then be used to deembed the DUT at selected
port(s).
Offset Embed Softtool
To Next Page
Loading...
