Command Reference
R&S
®
ZNB/ZNBT
787User Manual 1173.9163.02 ─ 54
Suffix:
<Ch>
.
Channel number of the previously defined S-parameter group.
Query parameters:
<Format> FDATa | SDATa | MDATa
Output format for the S-parameter data, see
CALCulate<Chn>:DATA on page 787.
Example: See CALCulate<Ch>:PARameter:DEFine:SGRoup
Usage: Query only
CALCulate<Chn>:DATA <Format>, <Data>...
CALCulate<Chn>:DATA? <Format>
The query reads the response values of the selected channel's active trace or reads
error terms of the selected channel.
The "set command" either imports formatted or unformatted trace data to the selected
channel's active trace (see Chapter 5.1.5, "Data Flow", on page 91) or writes error
terms of the selected channel.
Note
●
The data format is parameter-dependent; see tables below. The unit is the default
unit of the measured parameter; see CALCulate<Ch>:PARameter:SDEFine.
●
Unformatted trace data (SDATa) can only be imported to memory traces
●
Formatted trace data (FDATa) can only be imported to "live" traces if the related
channel is in single sweep mode (INITiate<Ch>:CONTinuous OFF).
Before the import, the target trace must be prepared according to the settings used
during export. Any request for new data from the hardware ("Restart Sweep" in sin-
gle sweep mode or switching to continuous sweep mode) discards imported data
and switches back the display to measured data.
Suffix:
<Chn>
.
Channel number used to identify the active trace
Parameters:
<Data> Trace data either in ASCII or block data format, depending on
the current FORMat[:DATA] setting.
Parameters for setting and query:
<Format> FDATa | SDATa | MDATa | NCData | UCData | SCORr1 |
SCORr2 | SCORr3 | SCORr4 | SCORr5 | SCORr6 | SCORr7 |
SCORr8 | SCORr9 | SCORr10 | SCORr11 | SCORr12 |
SCORr13 | SCORr14 | SCORr15 | SCORr16 | SCORr17 |
SCORr18 | SCORr19 | SCORr20 | SCORr21 | SCORr22 |
SCORr23 | SCORr24 | SCORr25 | SCORr26 | SCORr27
See list of parameters below.
SCPI Command Reference
To Next Page
Loading...
