Rohde & Schwarz ZNB - Page 908

Command Reference
R&S
®
ZNB/ZNBT
908User Manual 1173.9163.02 ─ 54
Example:
CALC4:PAR:SDEF 'Ch4Tr1', 'S11'
Create channel 4 and a trace named Ch4Tr1 to measure the
input reflection coefficient S
11
. The trace is the active trace in
channel 4.
CALC4:PAR:SDEF 'Ch4Tr2', 'S22'
Create another trace named Ch4Tr2 to measure the output
reflection coefficient S
22
. Again this new trace becomes the
active trace in channel 4.
CALC4:PAR:SEL 'Ch4Tr1'
Select the first trace Ch4Tr1 as the active trace.
CALC4:FORM MLIN
Calculate the magnitude of S
11
and display it in a linearly scaled
Cartesian diagram.
8.3.1.15 CALCulate:PHOLd...
The CALCulate:PHOLd... commands control the max hold (peak hold) function.
CALCulate<Chn>:PHOLd <HoldFunc>
Enables, disables, or restarts the max hold and the min hold functions.
Suffix:
<Chn>
.
Channel number used to identify the active trace
Parameters:
<HoldFunc> MIN | MAX | OFF
MIN - Enable the min hold function.
MAX - enable the max hold function.
OFF - disable the max hold or min hold function.
*RST: OFF
Example:
*RST; :CALC:PHOL MAX
Reset the instrument and enable the max hold function.
CALC:PHOL OFF; PHOL MAX
Restart max hold.
Manual operation: See "Hold" on page 333
8.3.1.16 CALCulate:RIPPle...
The CALCulate:RIPPle... commands define the ripple limits and control the ripple
limit check.
CALCulate:RIPPle:DISPlay:RESult:ALL[:STATe]............................................................... 909
CALCulate:RIPPle:FAIL:ALL?..........................................................................................909
CALCulate<Chn>:RIPPle:CLEar......................................................................................909
CALCulate<Chn>:RIPPle:CONTrol:DOMain......................................................................910
CALCulate<Chn>:RIPPle:DATA.......................................................................................910
CALCulate<Chn>:RIPPle:DELete:ALL..............................................................................911
CALCulate<Chn>:RIPPle:DISPlay[:STATe]....................................................................... 912
SCPI Command Reference