R&S ZVL GUI Reference
Trace Menu
Operating Manual 1303.6580.32-06
134
• Selecting one of the existing channel names assigns the current trace to the existing channel.
• Selecting New creates a new channel and assigns the current trace to the new channel. The new
channel is named Ch <n>, where <n> is the largest of all existing channel numbers plus one. The
name can be changed in the Channel Manager.
Remote control:
CALCulate<Ch>:PARameter:SDEFine <Trace Name>, < Meas Parameter>
Trace Manager
Opens a dialog to perform the actions in the Trace Select menu systematically for all traces and diagram
areas.
All existing traces of the current setup are listed in a table with several editable (white) or non-editable
(gray) columns. Below the table the Trace Manager provides the following buttons:
• Add/Delete... opens a dialog to add a new trace or delete a trace.
• Coupling opens a dialog to define coupling criteria (channel, scale) for all traces in the table.
• Sort Table opens a dialog to change the order of the traces (rows) in the table.
Columns in the Trace Manager table
• Name indicates the current trace name. The default names for new traces are Trc<n> where <n>
is a current number. Current numbers in the trace names are necessary to make automatic
assignments, e.g. decouple the channel settings in the Coupling dialog.
• On indicates whether the trace is displayed on the screen (On) or invisible.
• Meas indicates the measured parameter.
• Type indicates whether the trace is a data trace (DAT), displaying the current measurement data,
or a memory trace (MEM).
• Channel indicates the channel of each trace.
• Area indicates the diagram area of each trace.
• Scale shows which traces use common scaling and format settings.
Rules for trace names
For trace names, the following restrictions apply:
To Next Page
Loading...
