Rohde & Schwarz ZVL series - Page 177

R&S ZVL GUI Reference
Trace Menu
Operating Manual 1303.6580.32-06
162
• Ma
rker Tracking causes the search to be repeated after each sweep.
• D
ef Peak defines the criteria for the peak search.
• Search Range... assigns a search range to each marker of the current trace.
The search functions are available in all Cartesian and polar diagram types (see Trace – Format). In
polar diagrams (Polar, Smith, Inverted Smith), where complex values are displayed, the magnitude of the
response values provides the search criterion.
Max Search
Sets the active marker to the absolute maximum in the search range, i.e. to the largest of all response
values. If a complex trace format (e.g. a polar diagram) is active, the marker is set to the measurement
point with the maximum magnitude.
By default the search range coincides with the sweep range. If the active trace contains no markers, a
marker Mkr 1 is created to indicate the search result.
Remote control:
CALCulate<Chn>:MARKer<Mk>:FUNCtion:EXECute MAXimum
CALCulate<Chn>:MARKer<Mk>:FUNCtion:RESult?
Min Search
Sets the active marker to the absolute minimum in the search range, i.e. to the smallest of all response
values. If a complex trace format (e.g. a polar diagram) is active, the marker is set to the measurement
point with the minimum magnitude.
By default the search range coincides with the sweep range. If the active trace contains no markers, a
marker Mkr 1 is created to indicate the search result.
Remote control:
CALCulate<Chn>:MARKer<Mk>:FUNCtion:EXECute MINimum
CALCulate<Chn>:MARKer<Mk>:FUNCtion:RESult?
Peak Search >
Sets the active marker to the next peak with higher stimulus value. If the active trace contains no markers,
a marker Mkr 1 created to indicate the search result. The peak criteria are defined via Define Peak.
Remote control:
CALCulate<Chn>:MARKer<Mk>:FUNCtion:EXECute RPEak
CALCulate<Chn>:MARKer<Mk>:FUNCtion:RESult?
< Peak Search
Sets the active marker to the next peak with lower stimulus value. If the active trace contains no markers,
a marker Mkr 1 created to indicate the search result. The peak criteria are defined via Define Peak.
Remote control:
CALCulate<Chn>:MARKer<Mk>:FUNCtion:EXECute LPEak
CALCulate<Chn>:MARKer<Mk>:FUNCtion:RESult?
Target
Opens a submenu to search for a specific value on the trace.