R&S ZVL GUI Reference
Nwa-Setup Menu
Operating Manual 1303.6580.32-06
270
Quad Split
Splits the active window into four diagram areas and distributes the traces among the four areas,
separating diagrams with different trace Format and the Channel settings (e.g. Cartesian and polar
diagrams).
If less than four traces are available, some diagram areas are empty and display No Trace.
To vary the size and position of the diagram areas, drag and drop the separating frames or use the
Split Manager.
Remote control:
No command, display configuration only.
Split Manager
Opens a dialog to arrange the diagram areas in the active window.
• Split Mode provides a drow-down list to select alternative display schemes for the diagram areas
(see examples for split modes below).
• Number of Diagram Areas indicates the total number of diagram areas. Increasing/decreasing the
number creates new diagram areas or deletes diagram areas.
Examples for split modes
• The following examples were obtained with 3 diagram areas, each with 1 trace.
To Next Page
Loading...
