R&S ZVL Command Reference
Common Commands
Operating Manual 1303.6580.32-05
349
Command Parameters Short
Description
indicated. Bit 6 (MSS mask bit) remains 0. This command determines under which
conditions a service request is triggered. The query *SRE? returns the contents of the
service request enable register in decimal form. Bit 6 is always 0.
Enable
*STB? STatus Byte query reads the contents of the status byte in decimal form. Status Byte
Query; query only
*TRG TRiGger triggers all actions waiting for a trigger event. In particular *TRG generates a
manual trigger signal (Manual Trigger). This common command complements the
commands of the TRIGger subsystem.
Trigger;
no query
*TST? self TeST query triggers selftests of the instrument and returns an error code in
decimal form.
Self Test Query;
query only
*WAI WAIt to continue prevents servicing of the subsequent commands until all preceding
commands have been executed and all signals have settled (see also command
synchronization and *OPC).
Wait to continue;
no query
To Next Page
Loading...
