Rohde & Schwarz ZVL series - Page 559

R&S ZVL Command Reference
Instrument-Control Commands
Operating Manual 1303.6580.32-05
544
entry in the table SYSTEM MESSAGES. If the error list is empty, an empty string "" will be returned.
*RST value
–
SCPI, Command Types
Device-specific, query only
Example:
SYST:ERR:LIST?
Read system messages and display them in a list.
SYSTem:FIRMware:UPDate '<file_name>'
Installs a firmware version stored in a NWA setup file (*.msi) on the analyzer. The installation is automatic
and does not require any further action to be taken.
'<file_name>'
String variable for the name and directory of a NWA setup file (*.msi).
*RST value –
SCPI, Command
Types
Device-specific, no query
Example:
SYST:FIRM:UPD 'C:\Setup\ZVL_01.10.msi
Install the firmware version 01.10 from the setup file stored in the Setup
directoy of the analyzer's internal hard disk.
SYSTem:FORMat:IDENt ZVL | LEGacy
Adapts the return value of the *IDN? command to the R&S FSP/FSU/FSQ family. This function is
intended for re–use of existing FSP/FSU/FSQ control programs together with the R&S ZVL.
ZVL
Switches the FSP adaptation off. Example *IDN? return string:
'Rohde&Schwarz,ZVL-6,1303.6509K06/100007,1.10'.
LEGacy
Adapts the return value to the R&S FSP. Example *IDN? return string:
'Rohde&Schwarz,ZVL-6,100007/006,1.10'.
*RST value FSL
SCPI, Command
Types
Device-specific, command or query
Example:
SYST:FORM:IDEN FSL
Adapts the return value of *IDN? to the FSP.
SYSTem:PASSword[:CENable] '<password>'
Sends a password to the analyzer enabling a class of service functions to function (Command
ENable). Service functions are activated with the commands of the DIAGnostic system and should be
used by a R&S service representative only. Refer to the service manual for more information.
'<password>'
Case-sensitive string variable. Sending an invalid password generates error -