Rohde & Schwarz ZVL series - Page 566

R&S ZVL Command Reference
Instrument-Control Commands
Operating Manual 1303.6580.32-05
551
<memory_trc>
Name of the memory trace.
Range [def. unit] <memory_trace> is either a string variable (enclosed in single or double quotes)
or one of the following reserved names (no string variables):
MDATA1 | MDATA2 | MDATA3 | MDATA4 | MDATA5 | MDATA6 |
MDATA7 | MDATA8 (only for memory traces Mem<n>[Trc<m>], where n = 1, ...
8; see list of trace names). [–]
*RST value –
<data_trc>
Name of the data trace
Range [def. unit] <data_trace> is either a string variable (enclosed in single or double quotes) or
one of the following reserved names (no string variables):
CH1DATA | CH2DATA | CH3DATA | CH4DATA (only for the active data
trace in channels Ch1, Ch2, Ch3, Ch4; see list of trace names). [–]
*RST value –
SCPI, Command
Types
Confirmed, no query
Example:
*RST; SWE:POIN 20
Create a trace with 20 sweep points, making the created trace the active trace
of channel 1 (omitted optional mnemonic SENSe1).
TRAC:COPY "Mem_Pt20",CH1DATA
Copy the current state of the created trace to a memory trace named
"Mem_Pt20". The memory trace is not displayed.
DISP:WIND:TRAC2:FEED "MEM_PT20"
Display the created memory trace in the active diagram area (diagram area no.
1).
TRACe:COPY:MATH <memory_trc>,<data_trc>
Copies a mathematical trace to a memory trace. The trace to be copied can be specified by two
alternative methods:
 As the active mathematical trace of channels 1 to 4 (CH1DATA, CH2DATA, CH3DATA,
CH4DATA)
 As a trace with a name (string variable)
The created memory trace can be specified as follows:
 As the memory trace named Mem<n>[Trc<m>], where n = 1, ... 8 and Trc<m> is the name of the
copied data trace (MDATA1, MDATA2, MDATA3, MDATA4, MDATA5, MDATA6, MDATA7,
MDATA8)
 As a memory trace with an arbitrary name (string variable)
An existing memory trace with the same name is overwritten.
To copy a data trace which is not modified by any mathematical operations, use TRACe:COPY.
<memory_trc>
Name of the memory trace.
Range [def. unit] <memory_trace> is either a string variable (enclosed in single or double quotes)
or one of the following reserved names (no string variables):
MDATA1 | MDATA2 | MDATA3 | MDATA4 | MDATA5 | MDATA6 |