Roland BR-800 - Playback; Erasing a WAV File

EditingMasteringUsing USBConvenient
Functions
Appendixes Quick StartGetting Ready
to Record
Recording/
Playback
Using
Effects
Using
Rhythm
51
Simple Recording (SONG SKETCH)
6
Press the [REC] button.
Recording will begin.
The [PLAY] button will light green, and the [REC]
button will light red.
fig.Rec04-e.eps
7
When you’re finished recording, press the [STOP]
button.
The recorded data is saved in the SKETCH folder (p.
118).
The recorded data can be imported into a track.
“Importing song sketch data into a track” (p. 106)
Here’s how to play back a WAV file that was saved in the
SKETCH folder.
1
Press the [SONG SKETCH] button.
The SONG SKETCH screen will appear.
2
Use the CURSOR [ ] [ ] buttons to move the
cursor to the file name, and use the dial to select the
file that you want to play back.
3
Press the [PLAY] button.
Playback will begin.
4
To stop playback, press the [STOP] button.
Here’s how to erase a WAV file.
1
Press the [SONG SKETCH] button.
The SONG SKETCH screen will appear.
2
Use the CURSOR [ ] [ ] buttons to move the
cursor to the file name, and use the dial to select the
file that you want to erase.
3
Press the [MENU] button.
4
Use the CURSOR [ ] [ ] buttons to move the
cursor to “FILE,” and press [ENTER].
5
Use the CURSOR [ ] [ ] buttons to move the
cursor to “ERASE,” and press [ENTER].
The FILE ERASE screen will appear.
D_Song_Sketch_File_Erase.eps
6
If you want to erase the file, press the [ENTER]
button.
The screen will ask “Are you sure?”
7
Press the [ENTER] button
The file will be erased.
* The display will indicate “Keep power on!” while the data is
being updated. Do not turn off the power while this message
is shown.
Playback
LitLit
About file names
When a WAV file is saved, a file name will be
automatically assigned as follows.
(Ex.)
_BR_001.WAV
:
_BR_999.WAV
The file name will consist of _BR_ followed by a
sequential number and a file extension of .WAV.
Erasing a WAV File
BR800_e.book 51 ページ ２０１０年３月２日 火曜日 午後６時４０分