Roland CAMM-1 PNC-1610 - Page 35

27
Inst. Format Meaning of Parameter [Parameter Range (Default)] Explanation
SR
SR w, h; w : Character width (%) [*1 (3.8 cm)]
Relative Character Size
SR; h : Character height (%) [*1 (5 cm)]
SS SS; None Select Standard Set
TL
TL lp(,lm); lp : Tick length in positive direction [*2 (0.5%)]
Thick Length
TL; lm : Tick length in negative direction [*2 (0.5%)]
UC
UC (c,)∆x, ∆y,(c,) c : Tool control value [-(223-1) — -99, +99 — +(223-1)]
User Definesd
Character
,....,∆xn, ∆yn; ∆xn : Units of movement in X-axis direction [-99<∆xn<+99]
UC; ∆yn : Units of movement in Y-axis direction [-99<∆yn<+99]
VS
VS v; v : Tool speed (cm/sec.) [1 — 72 (value set by cotrol panel)]
Velocity Select
VS;
WD WD clc2 •••cn [label cn : Character [20h—7Fh,A0h — DFh]
terminator] Write To Display
WD [label terminator]
WG WG r,Ø1,Øc(,Ød); r : Radius [*1]
Ø1 : Start angle [1*] Shade Wedge
Øc : Center angle
Ød : Chord tolerance
XT XT; None X-Tick
YT YT; None Y-Tick
Inst. Format Meaning of Parameter [Parameter Range (Default)] Explanation
!NR
!NR ;
None
Not Ready
!PG
!PG;
n : Forced page feed[*1]
Page Feed
!PG (n );
!ST !ST n ;
n : [0, 1]
Select Tool
mode1, mode2 common instructions
* 1 : - ( 2
23
) — + ( 2
23
-1 )
* 2 : - ( 2
23
) °— + ( 2
23
-1 )°
* 3 : 0 — + ( 2
23
-1 )