Roland DUO-CAPTURE EX - Page 13

USB Driver Installation
13
6. When “Ready to install the driver.” appears, connect the DUO-CAPTURE EX to the
computer using the USB cable and set the [POWER] switch to the “on” position.
MEMO
• Do not connect any cables to the DUO-CAPTURE EX other than the USB cable.
• If a message appears, follow the instructions on the screen.
Windows XP
If using Windows XP, follow the instructions on the screen and continue the installation.
6-1. If a dialog box that asks whether you want to connect to
Windows Update appears, select the [No, not this time]
button and click the [Next] button.
6-2. Select the [Install the software automatically
(Recommended)] button and click the [Next] button.
6-3. If the “Hardware Installation” dialog box appears, click the
[Continue Anyway] button.
6-4. When “Completing the Found New Hardware Wizard” appears,
click the [Finish] button.
7. When “Installation has been completed.” appears, click the
[Close] button to close the “DUO-CAPTURE EX Driver Setup” dialog box.
The installer exits.
MEMO
If the “Change System Settings” dialog box appears, click the [Yes] button. Windows restarts.