E-600
July, 1999
Note: The calibration set will be memorized at the point " 3 " Factory Preset Setting" of the Test mode.
When the calibration fails, the following display will appear:
You have to carry out the calibration again.
Press the Part Balance [Accomp] button to go to the next test.
2. Display of the Device Check and Rom Version
Note: After the calibration, turn down the general volume so as to avoid hearing the audio noise.
This control starts automatically after the calibration step. The display may change as follows:
When no problem is found, "OK" will be shown on the top of the display.
On the contrary, the following error message will appear:
The devices and contents checked are as follows:
DEVICE CONTENTS
PROGRAM ROM checks the Checksum
DRAM checks the working of the DRAM for CPU
Wave rom checks the Checksum
DSP RAM checks the RAM for XPDSP
ESP RAM checks the RAM for ESP
DATA ROM checks the Checksum
DATA ROM TYPE checks the type of DATA ROM
FDC Ex Port checks the FDC port
When the Device Check ends, touch "Next" on the screen or press the Part Balance [Accomp] button to go to
the next test.
3. Factory Preset Setting
The following display will appear:
Touch "Go" on the screen or press Part Balance [Accomp] to start the loading of the Factory Preset Setting
in the internal memory.
For not loading the Factory preset setting in the memory, touch "Skip" on the screen.
4. Buttons and LEDs check
All the LEDs light up and the following display appears:
A piano sound should be heard and the LED corresponding to each pressed button turns off.
When you press the [Metronome], [Song] and [Page] buttons, the Beat indicators turn off.
When you press the buttons without LEDs the relative name indicated on the LCD disappears.
NOTE: If you press the Part Balance [Accomp]button first, you will go on to the following test. Once you
begin the checking process for this kind of test, it is not possible to go to the following one before checking
all the buttons. Press the Part Balance [Accomp] button in the end and you will go on to the following test.
5. Speaker Panning and Effect Sound check.
The following display will appear:
Press the following buttons to check the effects and the pannings:
BUTTON OUTPUT
Pop Sound PIANO 1 Direct sound
Piano Style PIANO 1 CHORUS sound
Ballad PIANO 1 REVERB sound
Rock PIANO 1 RESONANCE sound
Oldies Sine wave from the LEFT speaker.
Country Square wave from the RIGHT speaker.
Band/Swing Sine wave from both speakers.
Once the check ends, touch [Next] on the screen or press Part Balance [Accomp] to go on in the test mode.
18
To Next Page
Loading...
