Unpacking
Retaining materials are attached to protect the machine from vibration during shipment. Remove these after emplace-
ment.
Remove all Retaining materials. Any that remain may cause faulty operation or breakdown when the power is switched
on.
The Retaining materials are required when moving the machine to a dierent location. Store them carefully so that they
do not get misplaced.
WARNING
Carry out these operations before you connect the power cord.
Inadvertent powerup may result in pinched hands or other injury.
Procedure
Make sure the power cord is not connected.
Remove retainer A.
Slowly move the spindle head in the
direction of the arrow.
Take care not to subject it to strong impact.
Remove retainers B and C.
Retainer A
Hexagonal wrench
Spindle head
Hexagonal wrench
Retainer B
Retainer C
To Next Page
Loading...
