Roland EGX-350 - 2-4 Selecting the Language

31
Chapter 2 Installation and Setup
2-3 Cable Connections
Connecting the Power Cord
WARNING
Connect to an electrical outlet that complies with this machine’s ratings (for volt-
age and frequency).
Incorrect voltage or insufcient current may cause re or electrical shock.
WARNING
Handle the power cord, plug, and electrical outlet correctly and with care. Never
use any article that is damaged.
Using a damaged article may result in re or electrical shock.
WARNING
When using an extension cord or power strip, use one that adequately satises
the machine’s ratings (for voltage, frequency, and current).
Use of multiple electrical loads on a single electrical outlet or of a lengthy extension
cord may cause re.
WARNING
Connect to ground.
This can prevent re or electrical shock due to current leakage in the event of
malfunction.
WARNING
Connect to an electrical outlet. Never connect directly to a power distribution
panel or other such xed wiring equipment.
Doing so increases the hazard of re or electrical shock.
This machine requires a single-phase commercial power outlet, which rated at 1.3 A or higher ( for 100 to 120 V) or 0.6 A or
higher (for 220 to 240 V).
Right side
Electrical outlet
Power cable