55
4-3 Selection of the Cutter (Usage Examples)
This machine can use cutters of a wide variety of types that have a diameter of 3.175 millimeters or 4.36 millimeters.
Use an appropriate collet for the cutter’s diameter and type. For other cutters that can be used with the machine, contact
your authorized Roland DG Corp. dealer.
The table below shows samples of cutter usage, including use with or without a nose unit.
Important!
Use diameter-4.36 mm cutters at speeds of 15,000 rpm or lower. Use at higher speeds poses danger of damage to the spindle
unit due to vibration.
Cutter With nose unit No nose unit
Character cutter
Flat cutter
(*1)
Engraving acrylic and other plas-
tic plates (*2)
P. 56, “Cutter Installation Method 1”
Engraving plates of aluminum or brass
Three-dimensional engraving and creating
reliefs using plastic materials
P. 62, “Cutter Installation Method 2”
Diamond scraper
(*3)
Unsuitable Scribing plates of aluminum or brass
P. 67, “Cutter Installation Method 3”
End mill (*4)
Unsuitable Creating reliefs and performing 3D cutting
using plastic material
P. 71, “Cutter Installation Method 4”
*1: Diameter-4.36 millimeter cutters are optionally available items.
*2: Use of the nose unit is not suitable for ll engraving at a width greater than the diameter of the nose-unit tip.
P. 61, “Important Notes When Using the Nose Unit”
*3: This is an optionally available item. Also, the diameter-4.36 millimeter diamond scraper cannot be used with the included
solid collet. Provide a dedicated collet for diamond scrapers separately.
*4: This is an optionally available item. Provide a dedicated end-mill collet separately.
To Next Page
Loading...
