Roland EGX-400 - Replacement of Main Parts; 3-1 Spindle Motor Replacement

3 Replacement of Main Parts
34
3
3 Replacement of Main Parts
3-1 Spindle Moter_Replacement (Referential Time : 20 minutes)
2
Remove the Z Cable Cover, cut off the INSULOCK TIE and
disconnect the Spindle Motor Cable.
Spindle Motor Cable
Following table describes the necessary adjustment after the replacement of each parts.
Replacement Parts Necessary Adjustment
X MOTOR 1. X Axis Load Check
Y MOTOR 1. Y Axis Load Check
Z MOTOR 1. Z Axis Load Check
X AXIS LM GUIDE 1. X Axis Load Check
1. Right Angle Adjustment of X Axis
2. Y Axis Load Check
1. X Belt Tension Adjustment
2. X Axis Load Check
1. Right Angle Adjustment of X Axis
2. Y Belt Tension Adjustment
3. Y Axis Load Check
Y AXIS LM GUIDE
Y BELT
X BELT
Z Cable Cover
1
Remove the Spoindle Cover.
Spindle Cover