Roland EGX-400 - Page 63

3 Replacement of Main Parts
60
3
6
Loosen the screws from the Belt Holder and after that,
remove the X Belt.
7
8
Move the Z Slider to the bottom part by rotating the Z
Screws.
Put the new belt through the Belt Holder and tighten up the
Screws.
Screws
Belt Holder
Z Screw
X Belt
Screws
Belt Holder
X Belt
5
Loosen the Screw1 and remove the Screw2 and then loosen
the Nut2.
Nut2
Screw2
Nut1
Frame
Screw1