95
7 Service Activities
7
Accessories
Remove the
retainers.
1. Use the included wrench (10mm) and hexagonal wrench (3mm) to remove the
retainers on the side of the unit. Then, lower the unit from the base.
Operation panel : 1
Operation-panel
connector cable : 1
Power cord : 1
Depth regulator
nose unit : 1
Wrenches
(17 mm : 1, 10 mm : 1)
Solid collet : 1 (*1)
Hexagonal wrench
(3 mm) : 1
Hexagonal screw driver (2
mm) : 1
Roland Software Package
CD-ROM : 1
Clamps : 4 (*2)
User's Manual : 1
Follow the steps in "Unpacking and Repacking" on the packing carton to take out the
included items and accessories. Before you attempt installation, make sure all the included
items are present.
*1 This is for diameter 4.36 mm character cutters and flat cutters. It cannot be used with diamond
scrapers or end mills.
*2 The bolts and nuts are installed on the machine. (They are used for attaching the packing
retainers.)
To Next Page
Loading...
