Roland EM-303 - Drum Playback; Manual Drums Mode Operation

Changing the Split Point
Play Drums
When you're in the Arranger or the Lower Split Mode, you can change the split point
(the boundary between the lower and upper sections).
When the ARRANGER or LOWER indicator is lit, press and hold down
the SPLIT button.
After a short wait, the indicator starts to blink.
* Pressing the SPLIT button in the ordinary way changes the Split Mode. If you want
to change the split point, you have to hold down the SPLIT button until the indica-
tor begins to blink.
Press the key that you want to be the new split point.
°o °o °o
O unver CHORD MELIORY CHORD INTELL MELOOY INTELL
Gz: "Ce
* You can set different split points tor Arranger and Lower.
* The key you press to set as the split point is included in the upper section.
The EM-305/303 can play tones from a wide variety of pitched instruments, such as
the piano and violin, but it also has built-in drum sounds for percussion perfor-
mances. Manual Drums lets you use the keyboard to play these percussion sounds.
(| Press the SPLIT button in the MASTERS section to select Manual Drums.
See the Tone Chart (page 40) for a list of the percussion sounds assigned to the
keyboard.
26
er] aa pee Be Ba per] By Pe] Ea Psy Pes] Ee ea ce a] Ba re] er _ — -_
@ About Drum sets
On the EM-305/303, the drum
a sets vary according lo the se-
lected music style. Check out
a ihe Music Style Chart (page 41)
for the drum sets that are se-
a lectecl with each music style.