12
ep-760 Performance
■ Adjusting the volume balance in Dual performance (Dual Balance)
You can change the volume balance between the two layered sounds in Dual performance.
A Hold down the [Transpose] button, and press
the [Split] button.
The indicators of the buttons you pressed will flash.
The current volume balance appears in the display.
B Press the [+] or [–] button to change the value.
To return to the original volume balance, press the [+]
and [–] buttons simultaneously.
Press any button other than the [+] [–] buttons, and the
button’s indicator will return to the previous state.
When the power is turned on, this will be set to “8-2” (vol-
ume of the left button’s tone – volume of the right button’s
tone).
1 2
8-2
Volume of the right
button’s tone.
Volume of the left
button’s tone.
ep-760.GB Page 12 Thursday, May 16, 2002 8:03 PM
To Next Page
Loading...
