Roland ep-97 - Page 20

Owner's Manual
8.3 Control Changes
20
The Tones and their corresponding Program Change
numbers appear below:
Vibraphone
Harpsichord
Organ
Strings
Choir
Piano 1 + Piano 2
Piano 1 + E.Piano
Piano 1 + Vibraphone
Piano 1 + Harpsichord
Piano 1 + Organ
Piano 1 + Strings
Piano 1 + Choir
Piano 2 4 E.Piano
Piano 2 + Vibraphone
Piano 2 + Harpsichord
Progr Tone
19
20
21
22
23
Piano 2 + Organ
Piano 2 + Strings
Piano 2 + Choir
E.Piano + Vibraphone
E.Piano + Harpsichord
E.Piano + Organ
E.Piano + Strings
E.Piano + Choir
Vibraphone + Harpsichord
Vibraphone + Organ
Vibraphone + Strings
Vibraphone + Choir
Harpsichord + Organ
Harpsichord + Strings
Harpsichord + Choir
Organ + Strings
Organ + Choir
Strings + Choir
Messages known as “Control Changes” are used to
inform another device when you press a pedal, switch
on/off the Chorus or Reverb effect, etc.
Each time the power is turned on, the instrument will
be set to transmit/receive all Control Change mes-
sages.
If you set it to “Off” the ep-97/77 will no longer send
or receive Control Change messages.
While holding down the [Piano 1] button, [Piano 2]
button, and [Harpsichord] button, press the 'A5'
note to turn the setting On, or the “B5” note to turn
the setting Off.
Note: Refer to “Functions assigned to the keyboard” on
page 22 for the exact keys to press.
Note: If you want to know more about Control Change
Number, please refer to “MIDI Implementation” on page
23.
8.4 Transmitting song data from
MIDI OUT
If this setting is left “On”, the music recorded with the
ep-97/77 can be transmitted from the MIDI Out con-
nector. Each time the power is turned on, this setting
reverts to “Off”
Hold down the [Piano 1] button, the [Piano 2] but-
ton, and the [Harpsichord] button, and press the
“D6” note to turn the setting On, or the “E6” note to
turn the setting Off.
Note: Refer to “Functions assigned to the keyboard” on
page 22 for the exact keys to press.
B l Vibra- — Harpsi
Pianoi Piano? E.Piano phone chord
eee a @
es ees
While holding down three buttons
$
On Off
=
5 Press
Note: The data that you recorded will disappear when the
power of the ep-97/77 is turned off. If you wish to save the
recording on an external device, use the following proce-
dure.
1. Connect a MIDI sequencer such as the MT series
(see page 17).
2. Record the performance on the ep-97/77.
3. Set this setting to “On.”
4. Start recording with the connected MIDI device.
5. Start playback of the recorded song on the ep-97/
77.
6. When plavback ends, stop recording.
7. Use the connected MIDI sequencer to save the data
on a floppv disk or other media.