Roland ep-97 User Manual

outlet with an unreasonable number of other devices.
Be especially careful when using extension cords—the
total power used by all devices you have connected to
the extension cord's outlet must never exceed the
power rating (watts/amperes) for the extension cord.
Excessive loads can cause the insulation on the cord to
heat up and eventually melt through.
* Do not force the unit’s power-supply cord to share an S
: Before using the unit in a foreign country, consult with
your retailer, the nearest Roland Service Center, or an /N
authorized Roland distributor, as listed on the 'Tnfor-
mation' page.
 CAUTION
: The unit and the AC adaptor should be located so their
location or position does not interfere with their proper
ventilation.
tor when plugging into, or unplugging from, an outlet rt)
or this unit.
* Whenever the unit is to remain unused for an extended Q
period of time, disconnect the AC adaptor.
: Try to prevent cords and cables from becoming entan-
gled. Also, all cords and cables should be placed so they A
are out of the reach of children.
+ Never climb on top of, nor place heavy objects on the S
unit.
+ Never handle the AC adaptor body, or its plugs, with wet D
hands when plugging into, or unplugging from, an out- Ni
let or this unit.
AN CAUTION
: Ifyou need to move the instrument, take note of the
precautions listed below. At least two persons are
required to safely lift and move the unit. It should be
handled carefully, all the while keeping it level. Make
sure to have a firm grip, to protect yourself from injury
and the instrument from damage.
* Check to make sure the knob bolt securing the unit to the
stand have not become loose. Fasten them again securely
whenever you notice any loosening.
+ Disconnect the power cord.
* Disconnect all cords coming from external devices.
* Remove the music stand.
+ Before cleaning the unit, turn off the power and unplug
the AC adaptor from the outlet (p. 6).
+ Whenever you suspect the possibility of lightning in
your area, disconnect the AC adaptor from the outlet. Q
For the U.K.
IMPORTANT;
THE
WIRES
IN
THIS
MAINS
LEAD
ARE
COLOURED
IN
ACCORDANCE
WITH
THE
FOLLOWING
CODE.
BLUE: NEUTRAL
BROWN: LIVE
As
the
colours
of
the
wires
in
the
mains
lead
of
this
apparatus
may
not
correspond
with
the
coloured
markings
identifying
the terminals in your plug, proceed as follows:
The
wire
which
is
coloured
BLUE
must
be
connected
to
the
terminal
which
is
marked
with
the
letter
N
or
coloured
BLACK.
The
wire
which
is
coloured
BROWN
must
be
connected
to
the
terminal
which
is
marked
with
the
letter
L
or
coloured
RED.
Under
no
circumstances
must
either
of
the
above
wires
be
connected
to
the
earth
terminal
of
a
three
pin
plug.
(
€
This
product
complies
with
the
requirements
ot
European
Directive
89/336/EEC.
For EU Countries
For the USA
FEDERAL COMMUNICATIONS COMMISSION
RADIO
FREQUENCY
INTERFERENCE
STATEMENT
This
equipment
has
been
tested
and
found
to
comply
with
the
limits
for
a
Class
B
digital
device,
pursuant
to
Part
15
of
the
FCC
Rules.
These
limits
are
designed
to
provide
reasonable
protection
against
harmful
interference
in
a
residential
installation.
This
equipment
generates,
uses,
and
can
radiate
radio
frequency
energy
and,
it
not
installed
and
used
in
accordance
with
the
instructions,
may
cause
harmful
interference
to
radio
communications.
However,
there
is
no
guarantee
that
interference
will
not
occur
in
a
particular
installation.
It
this
equipment
does
cause
harmful
interference
to
radio
or
television
reception,
which
can
be
determined
by
turning
the
equipment
off
and
on,
the
user
is
encouraged
to
try
to
correct
the
interference by one or mare of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
—
Connect
the
equipment
into
an
outlet
on
a
circuit
different
from
that
to
which
the
receiver
is
connected.
— Consult the dealer or an experienced radio/TV technician for help.
Unauthorized
changes
or
modification
to
this
system
can
void
the
users
authority
to
operate
this
equipment.
This
equipment
requires
shielded
interface
cables
in
order
to
meet
FCC
class
B
Limit.
For Canada
NOTICE
This
Class
B
digital
apparatus
meets
all
requirements
of
the
Canadian
Interference-Causing
Equipment
Regulations.
AVIS
Cet
appareil
numérique
de
la
classe
B
respecte
toutes
les
exigences
du
Règlement
sur
le
matériel
brouilleur
du
Canada.
m
=a
G)
Es
VA)
x=

Roland ep-97 Specifications

General

Brand	Roland
Model	ep-97
Category	Musical Instrument
Language	English