Roland FR-4X - Page 50

50
Menu Options
Parameter Explanation/Value
RdGrwTyp
(Reed Growl Type)
Studio
Tradition
Steierische
Trikitixa
F-Jazz
Classic3
Bajan
RdGrw Lv
(Reed Growl Level)
To set the volume of the Reed Growl
sound.
Off, –40–Std–40
Rev Send
(Reverb Send)
Cho Send
(Chorus Send)
Use these parameters to set the Reverb
or Chorus, send levels (how much effect
should be applied to the bass section).
The higher the value you set, the more
the bass section (which includes the
chord buttons) will be processed by the
effect in question.
0–127
0–127
Bel Dtne
(Bellows Detune)
Here, you can specify how strongly
the pitch of the simulated Bass reed(s)
changes when you open or close the
bellows faster than usual.
If the “Standard” setting seems too mild,
try “High.” If it is too strong, use “Low.”
If you do not want any detuning effect,
select “Off.”
The most convincing setting usually
depends on the selected instrument(s).
Off
Low
Standard
High
B.MIDITX
(Bass MIDI Tx)
Pressing the [ENTER/YES] button lets you
make MIDI TX settings for the bass part.
C.MIDITX
(Chord MIDI Tx)
Pressing the [ENTER/YES] button lets you
make MIDI TX settings for the chord part.
MIDI TX
These parameters specify MIDI transmission for the currently
selected bass & chord part.
MIDI settings are made separately for the left hand bass buttons
and chord buttons.
These settings can be saved for each set, and you can use different
MIDI settings for each register within the set.
BASS MIDI TX
Parameter Explanation/Value
Note Tx
(Note Tx)
For details, refer to Accordion Edit - MIDI
TX (p. 46).
Octave
(Octave)
CC 00
(Control Change 00)
CC 32
(Control Change 32)
PC
(Program Change)
These parameters specify the program
change (PC) and bank select (CC00, CC32)
values.
You can use these three values to recall
sounds and memories.
If you choose “Off,” the message is not
transmitted.
If you choose “Std,” pressing a left
hand register button will transmit a PC
message of the same value as the left
hand register button number, a CC00
message of “0,” and a CC32 message of
“0.”
Std, Off, 0–127
Std, Off, 0–127
Std, Off, 1–128
Volume
(Volume)
For details, refer to Accordion Edit - MIDI
TX (p. 46).
Panpot
(Panpot)
Reverb
(Reverb)
Chorus
(Chorus)
Velocity
(Velocity)
Express
(Expression)
SustainA
(Sustain A)
This parameter allows you to enable the
transmission of sustain values (CC64) to
an external device.
The sustain can be controlled by Function
Switches (p. 76) or by an optional MIDI
foot controller (e.g. FC-300) connected to
the MIDI IN connector of FR-4x ( p. 80).
NOTE
This parameter belongs to the system
parameters.
This means that its setting is not affected by
changes in the set or the user program.
To save this parameter, save it as a system
parameter.
&
“How to Save System Parameters”
(p. 86)
Off, On
(Default: Off )