56
Menu Options
MIDI TX
These parameters specify MIDI transmission for the orchestra part.
These settings can be saved for each set, and you can use different
MIDI settings for each register within the set.
Parameter Explanation/Value
Note Tx
(Note Tx)
For details, refer to “Accordion Edit -
MIDI TX” (p. 46).
Octave
(Octave)
CC 00
(Control Change 00)
CC 32
(Control Change 32)
PC
(Program Change)
These parameters specify the program
change (PC) and bank select (CC00, CC32)
values.
You can use these three values to recall
sounds and memories.
If you choose “Off,” the message is not
transmitted.
If “Std” is selected, pressing a right hand
register button transmits a PC message
of the same number as the right hand
register button, a CC00 message of “0,”
and a CC32 message of “0.”
MEMO
These settings are shared with the Organ
part. In the case of the Organ part, CC32 is
transmitted as “1.”
Std, Off, 0–127
Std, Off, 0–127
Std, Off, 1–128
Volume
(Volume)
For details, refer to “Accordion Edit -
MIDI TX” (p. 46).
Panpot
(Panpot)
Reverb
(Reverb)
Chorus
(Chorus)
Velocity
(Velocity)
Express
(Expression)
Right Hand Organ Part Parameters (Organ Edit)
The parameters in the “OrgnEdit (Organ Edit)” group are for the
right hand organ part. The parameters can be saved to the selected
Set.
&
“Selecting Tones and Playing with the Right Hand” (p. 21)
&
“Selecting Parameters” (p. 44)
NOTE
These parameters can only be selected if the Organ section is
activated ([ORGAN] button indicator lights).
Introduction to Organ Parameters
These settings are for the sound of the register that’s selected for
the organ part.
Before you select a parameter and begin editing it, press the
RIGHT HAND [ORGAN] button to turn on the organ part, and
then press a right hand register button [1/8]–[7/14] to select the
sound that you want to edit.
NOTE
The FR-4x internal memory (temporary area) remembers your settings
while the FR-4x is switched on. While editing, there is no absolute need
to save your settings. Be aware, however, that all changes are lost when
the FR-4x is switched off .
See “How to Save a Set” (p. 33) to save your changes.
Also be sure to read “Important Remark About Saving Your
Settings” (p. 45).
NOTE
The Organ section and the Orchestra section cannot be used
at the same time.
Parameter Explanation/Value
(VTW Preset)
Select the Organ preset that you wish to
assign to the selected register.
The upper line of the screen shows the
organ sound name, and the lower line
shows the organ sound number.
5 “Usr”: This setting is the most recent of
the stored VTW organ tone.
5 “1”–“32”: 32 Organ preset (Not editable)
MEMO
5 For details regarding this settings
refer to the “Tone & Drum Kit List”
supplementary manual.
Download it from the Web:
http://www.roland.com/manuals/
5 “USR” is selected in the VTW organ tone
at the time of start-up.
Usr, 1–16
Volume
(Volume)
This parameter allows you to set the level
of the Organ section.
This setting is a value relative to the
standard “Std” setting.
Off, -40–Std–+40
To Next Page
Loading...
