11
Operating the Unit
fig.operation3.eps
4.
Adjust the amount of distortion with the
FUZZ knob.
The original distortion range of the select-
ed fuzz box model is reproduced when
the FUZZ knob is set anywhere from fully
counterclockwise to the center position.
Turning the knob past the center position
enables the BOOST range, which produc-
es distortion that exceeds that available
on the original model. The BOOST range
provides plenty of distortion, even when
using single-coil pickups.
fig.operation4.eps
5.
Adjust the output volume with the
LEVEL knob.
Normally, you should adjust the LEVEL
knob so there’s no difference in the vol-
ume when switching the effect on and off.
FZ-5_e1.fm 11 ページ ２００６年１２月１２日 火曜日 午前１１時３９分
To Next Page
Loading...
