Updating of the Operative System
There are 3 modes to update the G-70 Operative System.
Mode 1:
by means of a Card.
It is carried out by means of a card of at least 64 Mbytes and of a PCMCIA adaptor for this
card.
Mode 2:
by means of USB connection.
It is carried out by means of a connection USB PC Æ G-70.
Mode 3:
by means of a Floppy Disk (Rescue Mode).
It is carried out by means of the Rescue Floppy Disks and I used to update or recover an
instrument deprived of its operative system.
Mode 1 – Updating the Operative System by means of a card:
The point A. shown below may not be carried out if we have a card previously formatted
with the G-70.
It is also possible, and advisable, to use the same card where the musical data were
previously updated.
The card may include both the musical data and operative system.
A. Formatting a card with a G-70
x Switch on the instrument.
x Insert a Card into the PCMCIA slot (at least 64Mb).
x Press the switch “DISK & MEDIA”.
x Press the button “Format” on the touch screen.
x Press the button “External Memory on the touch screen.
Wait for the end of the formatting.
B. Copy the operative system into the “UPDATE” directory of the Card
x Insert the card with the relative adaptor into a PC.
x Cancel a possible previous operative system from the “UPDATE” directory of the card.
x Open the folder previously created in the PC containing the operative system.
x Copy, selecting and drawing the file “G70_Ver_01_XX.sys” of the operative system
from the PC into the “UPDATE” directory of the card.
ATTENTION!!!
Before withdrawing the card, disconnect the drive of the card from
the PC by means of the appropriate function. NOT MAKING THE DISCONNECTION
MAY CAUSE THE COPY OF THE FILES TO BE INCOMPLETE.
C. Updating the operative system
x Insert the card with its adaptor into the PCMCIA slot of the G-70.
x Switch on the instrument by keeping pressed the switch “DISK & MEDIA”.
x Wait for the instrument to show the video “Update All ” .
To Next Page
Loading...
