Roland G-70 - Page 23

Feb.2005
28
ATTENTION!, before withdrawing the USB cable and switching off the instrument,
disconnect the G-70 virtual drive from the PC by means of the appropriate function.
NOT MAKING THE DISCONNECTION MAY CAUSE THE COPY OF THE FILES TO BE
INCOMPLETE.
B. Updating the operative system
x Switch on the instrument by keeping pressed the switch “DISK & MEDIA”.
x Wait until the instrument shows the video “Update All ” .
x Press the switch “USER PROGRAM 1”.
x The G-70 will make a deep check of the system file; should the file be correct, it will
start the updating. A progression bar will show its status.
x At the end of the updating, switch off the instrument.
C. Factory Reset
x Switch on the instrument.
x Press the switch MENU.
x Press the button “UTILITY” on the touch screen.
x Press “FACTORY RESET”
x Press “EXECUTE” and wait until the operation is completed.
Mode 3
– Updating the Operative System by means of a Floppy Disk (Rescue Mode)
The Rescue Disks are meant to resume a first operative system.
Once the recovery is carried out, update the G-70 with the latest version by means of the
normal procedures described above.
A. Preparation of the Rescue Disk
x Format the floppy disk by means of a PC.
x Decompress the file “Disc 1.zip” and copy it’s content into the floppy disk “Disk1”.
x Perform the same operation for the Disc 2 and following ones.
B. Updating the operative system
x Switch on the instrument by keeping pressed the switches “USER PROGRAM 1” and
“USER PROGRAM 2”.
x Insert the disc “Disk1” into the G-70’s floppy drive.
The G-70 will start the updating. Red horizontal bars will show its status. Green and black
horizontal bars will show the end of the updating of disc 1.
x Switch off the instrument.
x Switch on the instrument again by keeping pressed the switches “USER PROGRAM 1”
and “USER PROGRAM 2”.
x Insert the disc “Disk2” into the G-70’s floppy drive.
The G-70 will start the updating. Red horizontal bars will show its status. Green and black
horizontal bars will show the end of the updating of disc 2.
x Switch off the instrument.
x Perform the same operations for the remainder discs.