Roland G-800 - User Style Edit mode

G-800 Reference Manual
A LAL AE LL AT Te PS ESB SI ST SE SP EE SR SSE As
E Execute
Press Part Select [M.DRUMS] to copy the selected source data if you only wish to make one
copy. Otherwise, go on to the next display page.
mM Listen
Press Part Select [UPPER1] to listen to the destination pattern you are about to overwrite. Lis-
ten always plays back the entire pattern.
User Sti\Copy\ To 2 page
Into Timez
=
EEEE] z EE]
I i 1
* $ ` r k as ` a
BAR BEAT CPT
D Master page: [F4] (UsrStl)> [SHIFT] + [F1] (Copy)
[PAGE] A/V (select To 2)
This page allows You to set the Into position, i.e. the bar, beat and CPT value the first data of
the source pattern will be copied to.
E Bar, Beat, CPT
See page 52 for details,
E Times (1-99)
Sets the number of copies you wish to make. Note that the value “3” means that you will end
up with 3 contiguous copies, whereby the second copy is placed immediately after the first,
etc.
m@ Execute
Press Part Select [M.DRUMS] to copy the selected source data.
User Style Edit mode
Most display pages of the User Style Edit mode feature a function that allows you to
jump back to the first User StylelRec page. Use it after editing a track (or all tracks) to record
new material straight away.
Before discussing the various User Style Edit functions, we would like you to remember the
following: certain functions allow you to select the data type to be edited. Whenever that is
the case, you can select one of the following messages. Let us call these the Data types.
——— _ a ——
Parameter Meaning
All All editable parameters listed below.
Note Only note messages.
Modul Only modulation messages (CC1 in MiDlese).
PanPt Only pan {or Panpot) messages (CC10).
Expre Only Expression messages (CC11).
54