Roland GAIA 2 - Page 59

59
Navi
MFX List
02 SuperFilter
This is a lter with an extremely sharp slope. The cuto frequency can be varied cyclically.
L inL in L outL out
R outR outR inR in
Super Super
FilterFilter
Super Super
FilterFilter
Parameter Value Explanation
Type
LPF, BPF, HPF, NOTCH
Filter type.
Frequency range that will pass through each lter.
LPF: Frequencies below the cuto
BPF: Frequencies in the region of the cuto
HPF: Frequencies above the cuto
NOTCH: Frequencies other than the region of the cuto
Slope
-12, -24, -36 [dB]
The slope of the lter (attenuation characteristics; amount of attenuation
per octave).
-12 dB: Gentle
-24 dB: Steep
-36 dB: Extremely steep
Cuto
0–127
Cuto frequency of the lter.
Increasing this value will raise the cuto frequency.
Resonance
0–100
Filter resonance level.
Increasing this value will emphasize the region near the cuto frequency.
Gain
0–+12 [dB] Amount of boost for the lter output
Mod Sw
OFF, ON On/o switch for cyclic change
Mod Wave
TRI, SQR, SIN, SAW1, SAW2
How the cuto frequency will be modulated.
TRI: Triangle wave
SQR: Square wave
SIN: Sine wave
SAW1: Sawtooth wave (upward)
SAW2: Sawtooth wave (downward)
SAW1 SAW2
Rate Sync
OFF, ON If this is ON, the rate synchronizes with the tempo of the rhythm.
Rate
0.05–10.00 [Hz] Frequency of modulation
Rate Note
Note
1/64T, 1/64, 1/32T, 1/32, 1/16T, 1/32., 1/16, 1/8T, 1/16., 1/8, 1/4T, 1/8., 1/4,
1/2T, 1/4., 1/2, 1T, 1/2., 1, 2T, 1., 2
Depth
0–127 Depth of modulation
Attack
0–127
Speed at which the cuto frequency will change This is eective if Mod
Wave is SQR, SAW1, or SAW2.
Level
0–127 Output Level