Roland GAIA 2 - Page 61

61
Navi
MFX List
Parameter Value Explanation
Drive Sw
OFF, ON Overdrive on/o
Drive
0–127
The degree of distortion.
Also changes the volume.
Vowel1
a, e, i, o, u Vowel 1
Vowel2
a, e, i, o, u Vowel 2
Rate Sync
OFF, ON If this is ON, the rate synchronizes with the tempo of the rhythm.
Rate
0.05–10.00 [Hz] Frequency at which the two vowels switch
Rate Note
Note
1/64T, 1/64, 1/32T, 1/32, 1/16T, 1/32., 1/16, 1/8T, 1/16., 1/8, 1/4T, 1/8., 1/4,
1/2T, 1/4., 1/2, 1T, 1/2., 1, 2T, 1., 2
Depth
0–127 Eect depth
In Sync Sw
OFF, ON
Turns LFO reset on/o.
Determines whether the LFO for switching the vowels is reset by the input
signal (ON) or not (OFF).
InSyncThres
0–127 Volume level at which reset is applied
Manual
0–100
Point at which Vowel 1/2 switch
0–49: Vowel 1 will have a longer duration.
50: Vowel 1 and 2 will be of equal duration.
51–100: Vowel 2 will have a longer duration.
Low Gain
-15–+15 [dB] Amount of boost/cut for the low-frequency range
High Gain
-15–+15 [dB] Amount of boost/cut for the high-frequency range
Pan
L64–63R Stereo location of the output sound
Level
0–127 Output Level
06 Side Band Filter
A sideband lter that only allows specic frequency components to pass through.
L inL in L outL out
R outR outR inR in
Balance/D
Balance/D
Side Side
Band Band
FilterFilter
Side Side
Band Band
FilterFilter
Gain
Gain
Balance/W
Balance/W
Parameter Value Explanation
Band Interval
0–100
The band interval.
Larger values produce wider band intervals, and the frequency of each
band increases.
Band Width
0–100
The bandwidth setting.
Larger values produce a narrower bandwidth, which further isolates the
specic frequency components that pass through the lter.
Balance
D100:0W–D0:100W
Volume balance between the sound that is sent through the sideband
lter (W) and the sound that is not sent through the sideband lter (D).
Type
SBF1, SBF2, SBF3, SBF4,
SBF5, SBF6
The range in which the lter works.
Gain
0–+18 [dB] Output gain for the sound that passes through the sideband lter
Level
0–127 Output Level