67
Navi
MFX List
Parameter Value Explanation
Rate Note
Note
1/64T, 1/64, 1/32T, 1/32, 1/16T, 1/32., 1/16, 1/8T, 1/16., 1/8, 1/4T, 1/8., 1/4,
1/2T, 1/4., 1/2, 1T, 1/2., 1, 2T, 1., 2
Depth
0–127 Depth of modulation
Phase
0–180 [deg] Spatial spread of the sound
Feedback
-98–+98 [%]
Adjusts the proportion of the anger sound that is fed back into the eect
(Negative values invert the phase).
Low Gain
-15–+15 [dB] Amount of boost/cut for the low-frequency range
High Gain
-15–+15 [dB] Amount of boost/cut for the high-frequency range
Balance
D100:0W–D0:100W Volume balance between the direct sound (D) and the anger sound (W)
Level
0–127 Output Level
15 SBF-325 (Flanger)
This eect reproduces Roland’s SBF-325 analog anger.
It provides three types of anging eect (which adds a metallic resonance to the original sound) and a chorus-type eect.
L inL in L outL out
R outR outR inR in
SBF-325SBF-325
Parameter Value Explanation
Mode
Types of anging eect
FL1 A typical mono anger
FL2 A stereo anger that preserves the stereo positioning of the original sound
FL3 A cross-mix anger that produces a more intense eect
CHO A chorus eect
Rate Sync
OFF, ON If this is ON, the rate synchronizes with the tempo of the rhythm.
Rate
0.02–5.00 [Hz] Modulation frequency of the anger eect
Rate Note
Note
1/64T, 1/64, 1/32T, 1/32, 1/16T, 1/32., 1/16, 1/8T, 1/16., 1/8, 1/4T, 1/8., 1/4,
1/2T, 1/4., 1/2, 1T, 1/2., 1, 2T, 1., 2
Depth
0–127 Modulation depth of the anger eect
Manual
0–127 Center frequency at which the anger eect is applied
Feedback
0–127
The intensity of the anging eect.
If Mode is CHO, this setting is ignored.
RMod Phase
NORM, INV
The phase of the right channel modulation.
Normally, you will leave this at Normal (NORM).
If you specify Inverted (INV), the modulation (upward/downward
movement) of the right channel is inverted.
L Phase
NORM, INV
The phase of the anging sound when mixed with the original sound.
NORM: normal phase
INV: inverse phase
R Phase
NORM, INV
Level
0–127 Output Level