Roland GAIA 2 - Page 90

90
Navi
MFX List
Parameter Value Explanation
Loop Mode
OFF, AUTO, ON
If this is AUTO, the loop automatically turns on/o in synchronization with
the rhythm.
If the eect is recalled with this ON, this parameter must rst be set to
something other than ON in order to make the loop operate.
Level
0–127 Output Level
Lo-
48 LOFI Comp (Lo-Fi Compressor)
Degrades the sound quality.
CompressorCompressor
Lo-FiLo-Fi
2-Band 2-Band
EQEQ
CompressorCompressor
Lo-FiLo-Fi
2-Band 2-Band
EQEQ
L inL in L outL out
R outR outR inR in
Parameter Value Explanation
Pre Filter
1–6
Selects the type of lter applied to the sound before it passes through the
Lo-Fi eect.
1: Compressor o
2–6: Compressor on
LoFi Type
1–9
Degrades the sound quality. The sound quality grows poorer as this value
is increased.
Post Filter
OFF, LPF, HPF
Selects the type of lter applied to the sound after it passes through the
Lo-Fi eect.
OFF: No lter is used
LPF: Cuts the frequency range above the Cuto Freq
HPF: Cuts the frequency range below the Cuto Freq
Cuto
200–8000 [Hz] Basic frequency of the Post Filter
Low Gain
-15–+15 [dB] Amount of boost/cut for the low-frequency range
High Gain
-15–+15 [dB] Amount of boost/cut for the high-frequency range
Balance
D100:0W–D0:100W Volume balance between the direct sound (D) and the eect sound (W)
Level
0–127 Output Level