Roland HandSonic HPD-15 - Sound Parameters and LFO Effects

36
Chapter 2 Modifying a Patch
Adjusting Sounds
Select the sound that you wish to play by using the pads, D
Beam, or ribbons. You can also adjust the pitch or duration of
the sound.
* Some parameters have relation to the parameters in EZ Edit
mode. If there are problems (e.g., no sound), check the
parameters in EZ Edit mode.
Parameter Category: PAD INST
fig.2-07.e
(Inst) : Refer to Instrument List (p. 92)
Selects the sound (instrument.)
* You can jump to the first sound in each instrument group by
using the Skip function (p. 33).
Pad Level: 0–127
Adjusts the volume.
Pan: L63–Center–R63, Random, Alternate
Adjusts the pan (localization) of the output sound.
Random: The pan changes randomly each time the pad is struck.
Alternate: The pan alternates left and right each time the pad is
struck.
Reverb Send: 0–127
Adjusts the depth of the reverberation.
Pitch: -2400–+2400cent
Adjusts the pitch.
100 cents is a semitone.
* You can change the pitch in steps of 100 cent by using the Skip
function (p. 33).
Decay: -31–+31
Adjusts the duration (decay time.)
* Some sounds do not change the duration.
Color: -31–+31
Adjusts the tone.
Sweep: -31–+31
Changes the pitch.
Positive (+) values will cause the pitch to change from high
to low. Negative (-) values will cause the pitch to change
from low to high.
MULTI-FX/LFO: OFF, ON
Turns the multi-effects and LFO on or off.
TrigMode: Shot, Gate, Trig (Pad)
Move, MovGate, Touch, TchGate,
Scrape, Scrp1wy (D Beam, Ribbon)
Selects how the sound will be played.
• Pad
Shot * : When you strike the pad, the sound will
play for the duration specified for that
particular sound.
Gate * : The sound will play while you continue
pressing the pad. This is effective when
you have selected a sustaining sound.
Trig: The sound will play when you strike the
pad, and will stop when you strike the pad
once again. This is effective when you have
selected a sustaining sound.
• D Beam, Ribbon
Move: The sound will play when you place your
hand above (or touch with your finger) and
move.
MovGate: The sound will play when you place your
hand above (or touch with your finger) and
move. If a sustaining sound is selected, the
sound will continue playing until you stop
your hand or finger.
Touch: The sound will play when you place your
hand above (or touch with your finger).
TchGate: The sound will play when you place your
hand above (or touch with your finger). If a
sustaining sound is selected, it will
continue playing until you move your
hand or finger away.
Scrape * : The sound will play when you move your
hand or finger. This is used to play sounds
such as guiro.
• only D Beam
Scrp1wy * : The sound will play continuously when
you move your hand. The sound will play
for only one direction.
* Pedal can be specified the value marked with “*.”
U0101A1 PAD INST
Pad Level 100
Parameter
Value
U0101A1 PAD INST
L09:Conga Hi /H
Inst NameInst Group
(Inst select screen)
(Other value select screen)