Roland HP-203 - IMPORTANT SAFETY INSTRUCTIONS; Safety Instructions for Fire, Electric Shock, or Injury

Roland Corporation US page 3
Exploring the HP-203
iii. While the display indiciates “dPr” you may use the -/+ buttons to change the
setting.
8. Can we change the ‘SPLIT POINT’?? ([OM page 36]
a. To change the keyboard’s SPLIT POINT simply hold down the SPLIT button and while
continuing to hold the SPLIT button down touch the key where the split point is desired.
b. NOTE: The default SPLIT POINT is at the F# just below middle C.
9. DIVERSION back to orchestration/arranging class
a. Think Solo vs. Ensemble instruments
b. Suggested possibilities
i. Piano in LH – Flute in RH
ii. Bass in LH – Vibraphone in RH
10. Performing with the METRONOME – [OM page 37]
a. To activate the METRONOME, push the METRONOME button. You will hear the
metronome and the light in the metronome button will flash red on the downbeat..
b. To change the TEMPO:
i. Press the TEMPO/BEAT button to make the TEMPO indicator light.
ii. The current tempo will be indicated in the display.
iii. To adjust the tempo use the -/+ buttons.
c. To change the BEAT:
i. Press the TEMPO/BEAT button to make the BEAT indicator light.
ii. The current beat will be indicated in the display.
iii. To adjust the beat use the -/+ buttons.
d. To change the metronome VOLUME, hold the Metronome button down and while
continuing to hold the metronome button down use the -/+ to adjust the volume.