Roland HP 237 - Power On;Off and Volume; Music Stand Installation

Getting Started
Turning the Power On and
Off
¡NOTE|
Once the connections have been completed, turn on power to your
various devices in Hie order specified. By turning on devices in Hie
wrong order, you risk causing malfunction and/or damage to
speakers and other devices.
E Turning on the power
1. Before you switch on the power, turn the
volume all the way down by using the
[Volume] slider.
Min Volume Max
2. Press the [Power] switch, to turn on the
power.
Lower position
—_
ON
After a few seconds, the keyboard will produce sound
when played. Adjust the volume appropriately.
(NOTE)
This unit is equipped with a protection circuit. A brief interval (a
few seconds) after power up is required before the unit will operate
normally.
@ Turning off the power
1. Before switching the power off, turn the
volume all the way down by using the
[Volume] slider.
in Volume Max
2. Press the [Power] switch, to turn off the
power.
Upper position
a, Y
OFF
The power is turned off.
Adjusting the Volume
Use the [Volume] slider to adjust the overall volume.
Min Volume Max
US
Setting the Music Stand
Insert the music stand into the two holes as shown in the
figure below.
[NOTE
Before moving the HP 237, be sure to remove the music stand as a
safety precaution.
O