Roland HP 2700 - Setting the MIDI Transmit;Receive Channels

Put the Template in Place
3. Using MIDI
Whenever you wish to make any settings for MIDI, it is helpful to have the supplied template in place on the panel.
KEY TEMPERA: PIANO 1 PIAND 2 HONKY HARPS! VIBRA ft PIANO
TRANSPOSE MENT TONK CHORD PHONE
CHORUS TREMOLO eee AE VI VALUE DEMO
ROOM - ane e HALL
aE Se a a | eanfee Cass
ao PTR os wer MEAN aes sean STRETCH Bee
Lges the template
* While you are pressing the KEY-TRANSPOSE (MIDI) button, the instrument cannot be played.
Setting the MIDI Transmit/Receive Channels
MID! allows you to play sounds on a remote
unit, or change the sounds used (only if the
channels used on the transmitter and receiver
are matched.).
If the MIDI channels are not matched, no sound
will be produced. Confirm that you have the
channels set correctly.
To set the transmission and reception channels
o to the same channel:
@ Press the KEY-TRANSPOSE button and con-
firm that the indicators on the Piano 1 and
Piano 2 buttons are both blinking. If only
one of them is blinking, hold down the
KEY-TRANSPOSE button while you press
both buttons.
@ While holding down the KEY-TRANSPOSE
(MIDI) button, press the key which corre-
sponds to the desired MIDI channel. (See
illustration below.)
KEY
TRANSPOSE
Press the key that corresponds
to the MIDI channel you want
To set separate channels for the transmission
7 and reception channels:
@ Setting the Transmit Channel
Hold down
@ While holding down the KEY-TRANSPOSE
(MIDI) button, press the PIANO 1 (TX CH)
button.
KEY PIANO 1
TRANSPOSE
Hold down
@ While still holding down the KEY-TRANS-
POSE (MIDI) button, press the key which
corresponds to the desired MIDI channel.
(See illustration below.)
KEY
TRANSPOSE
Hold down Press the key that corresponds
to the MIDI channel you want
@ Setting the Receive Channel
@ While holding down the KEY-TRANSPOSE
(MIDI) button, press the PIANO 2 (RX CH)
button.
KEY PIANO 2
TRANSPOSE
Hold down
@ While still holding down the KEY-TRANS-
POSE (MIDI) button, press the key which
corresponds to the desired MIDI channel.
(See illustration below.)
KEY
TRANSPOSE
Press the key that corresponds
to the MIDI channel you want
Hold down
18