Roland HP 2700 - Selecting the Transmission;Reception Mode

3. Using MIDI
Selecting the Transmission/Reception Mode |
Three Transmission/Reception Modes have been
provided to allow you to select the mode which Chorus On/Off Control No. 93
best matches your needs.
Tremolo On/Off Control No, 92
* Note and Pedal messages can be received and transmit-
ted regardless of the mode selected.
Volume Control No.7
Allows for transmission/reception of Program Roland Exclusive Messages
Change messages. (Data used to make changes
in the Voice used.)
Program Change messages can be transmitted by
holding down the KEY-TRANSPOSE (MIDI) btton
and then pressing the relevant key. (See chart .
below.) Such messages are not sent out when
simply changing the Voice using the panel.
Allows for transmission only of Program Change, = @ While holding down the KEY-TRANSPOSE
Chorus, and Tremolo On/Off messages. Program Lieve button, press the E. PIANO (MODE)
Change messages can be transmitted by holding Seg
down the KEY-TRANSPOSE (MIDI) button and bias sak eecineing PIANO (MODE) but-
then pressing the relevant key. (See chart below.) tat, :
They aa ss a out when Saale changing the The indicator on one of the REVERB (I/II/III)
Voice using the panel buttons will be blinking. This indicates the
When set to this mode, the Voice will not be Mode that is currently is in effect.
changed even if Program Changes are received.
It is thus convenient to use in combination with
Omni On when wishing to have the instrument
played using the Note messages on all channels.
@ While holding down the KEY-TRANSPOSE
(MIDI) button, press the REVERB (I/Ii/Iil) but-
ton you need to make your selection.
ae F KEY E_ PIANO Ri
Allows for transmission/reception of Chorus, TRANSPOSE ROOM SiAGE HALL
Temperament messages. MODE a
Program Change messages will be sent out when Lf)
changing the Voice using the panel (See MIDI
implementation.). At the same time, the Chorus Hold down
and Tremolo On/Off messages for the Voice will ® @
be transmitted along with them.
This mode is convenient to use when wishing to
record a performance into a sequencer, or similar
device.
Tremolo, Reverb On/Off, Volume, Brilliance, and a CaCI Co
1 a
Transmitting Program Change messages (Mode |, Il)
KEY
TRANSPOSE
Group B
iy Hold down
Number
Middle C
eee]
eof
Press the keys that correspond to the
program change number you want.